How do I set up a HART device?
Posted on August 11, 2021 in
- Wire the sensor to the RANGER’s HART card. Make sure to remove the jumper if the sensor is being externally powered
- Connect to the RANGER with the RANGER ToolKit
- Go to the HART tab
- Click on “Configure HART device”
- If the RANGER is set up for Sensor Always On or the sensor is externally powered, click Scan
- Otherwise, turn on power to the loop and wait for the sensors to turn on, then click Scan
- The connected sensors will appear at their configured HART ID
- Close out of the window and then check off which HART IDs you would like the RANGER to read and send to the Cloud